Command-Line Options - Xilinx EZTag User Manual

EZTag with Workstations
file design.jed to the target system and initiate a readback immediately
after the configuration data has been downloaded.
To execute a readback after the device has been in operation, use the
interactive commands, as follows:
This command invokes the interactive mode, and the EZTAG ?
prompt appears.
The part commands identifies the number the number, type, name
and order of devices in the boundary-scan chain. In this case there is
one device only. Then to program the device, enter:
The program command downloads design.jed to the target device. If
you want a readback after the target device is in operation, you can
execute the Verify command.
This command initiates a readback, and compares the data to the
design.jed file.
You may also execute the program and verify operations in one step
by typing:

Command-Line Options

This section describes the EZTag command-line options. The data
files are configuration bitstream files in JEDEC format. When you do
not specify any options or data files, the XChecker system defaults to
the interactive mode. If you do not specify any options but you do
specify a data file, a default set of options specified in the
xchecker.pro file sets the port.
The command-line syntax is as follows:
Note: You can abbreviate all options to the minimum number of
distinctive characters in the option name.
4-4
eztag
part part_type:design_name
eztag ? program design_name
eztag ? verify design_name
eztag ? program -v design_name
eztag options datafile
Xilinx Development System