Appendix A Error Messages; Introduction; Error Messages - Xilinx EZTag User Manual

Error Messages

Introduction

This section describes the error messages that EZTag may generate.
Following each error message, there is a suggested workaround.
Error Messages
Make sure that the command file you specified is in the current
directory or the environment search path. Make sure that the
command file has the ".cmd" extension
This is an internal program error that normally should not occur. Try
entering the command sequence again. If the error persists, try
reinstalling your EZTag software. If the error reappears, call Xilinx
Technical Support. Be prepared to duplicate the error and reference
specific files or examples.
The Diagnostics command, as well as other readback and verification
commands are only supported for the XChecker cable.
Check available disk space. Current directory or file must have write
permission.
Check available disk space. Current directory or file must have write
permission.
EZTag User Guide
Error 001: Command file bat file.cmd is not found.
Error 002: Internal Error — Command table syntax error
Cmd=valid_command.
Error 003: Diagnostic is not supported on this cable.
Error 010: Cannot open output file file_name.
Error 011: Cannot create output file file_name.
Appendix A
A-1