Xilinx EZTag User Manual page 59

should be contacted.
The specified device instance could not be programmed. Check if
data protect or data security is enabled as this disables the
programming functionality. If data security is enabled, first issue an
"erase" command then execute the program command. Also check
for the integrity of the cable connections.
The specified device instance could not be verified. Check if data
security is enabled as this disables the readback functionality. If
this is not the case, check for the integrity of the cable connections.
If error persists you may have a bad part and Xilinx customer service
should be contacted.
The specified device instance could not be verified. Check if data
security is enabled as this disables the readback functionality. If
this is not the case, check for the integrity of the cable connections.
If error persists you may have a bad part and Xilinx customer service
should be contacted.
Check that the specified part exists in the boundary-scan chain that
you declared in your "part" command. A new "part" command will
override the previously specified one. The current "part" database
can be displayed by typing "part" followed by a carriage return.
Verification of the integrity of the boundary-scan chain failed. Check
EZTag User Guide
Error 1005: Unable to program address string of
instance string with data string .
error 1006: Unable to verify address string of
instance string against data string .
error 1011: Verification failed at address value of
instance string. Expected: value . Read: value .
Error 1014: A description for a device named string
has not been supplied. Please make sure that a
BSDLdescription was loaded for this device.
Error 1015: A description for an instance named string
of any device has not been supplied. Please make sure
that a JTAG connection description was supplied for
this device.
Error 1017: The boundary scan chain instruction
register bit sequence is incorrect at bit value . This
corresponds to a scan chain break at or near part
string.
Error Messages
A-7