Quit - Terminate Session; Reset - Reset Target Lca/Cable; Save - Save Option Settings - Xilinx EZTag User Manual

contained in the associated JEDEC file.
-s sets data security in the device. This disables readback of
the device'
to reprogram it.
-p sets data protect in the device. This disables over-write of the
device's programmed contents. The device cannot be erased or re-
programmed.
Quit — Terminate Session
Syntax
Abbreviation
The Quit command terminates the current EZTag session and asks
you whether to save current program options in the xchecker.pro file.
Reset — Reset Target LCA/Cable
Syntax
Abbreviation
The Reset command resets the boundary-scan TAP state machines or
the XChecker cable. The default is to reset the boundary-scan TAP
state machines.
There is one option for the Reset command.
–cable
The –cable option reprograms the XChecker cable's internal FPGA. It
re-initializes the cable, including setting the correct baud rate. This
option is useful in the event of power glitches that could affect proper
cable operation.
With this option, you could remove power from the target system,
then restore power, while running EZTag; the Reset command
re-initializes the cable to the proper settings.
Save — Save Option Settings
Syntax
EZTag User Guide
s programmed contents. The device must be erased
quit
qu
reset [–cable]
res
save
EZTag with Workstations
4-11