Port - Specify Download/Readback Port; Program - Xilinx EZTag User Manual

EZTag with Workstations
Abbreviation
The partinfo command returns the manufacturer's identification (id),
the user signature (-signature) or the device checksum (-checksum)
for a particular part_name. Any or all of the three switches may be
specified in a single command. The part_name must have been
specified in the part command.
Port — Specify Download/Readback Port
Syntax
Abbreviation
The port command specifies the download/readback port. Table 3-5
lists the valid entries; the ports listed in bold face are the defaults. If
the port is defined as Auto, all ports are scanned to search for a cable.
Table 4-3 Valid Ports for the XChecker Cable
*Use with the parallel download cable only (no readback).
**ttya and ttyb must be readable and writable to ensure a proper connection.

Program

Syntax
Abbreviation
This command programs the specified part. If the part_name is the
same as the JEDEC file_name, then the file_name does not need to be
specified. The part_name must have been set in the part command.
There are four options that may be specified (individually or
together):
4-10
port portname
po
Platform
IBM PC com1
NEC PC com1
Sun /dev/ttya**
HP700 /dev/tty00
program [-v] [-t] [-s] [-p] part_name [-j file_name]
-v after programming the device reads back the contents and
verifies that they agree with the associated JEDEC file.
-t executes a functional test after programming using the vectors
Communication Ports
com2 lpt1*
/dev/ttyb**
/dev/tty01
Xilinx Development System
lpt2*