Xilinx EZTag User Manual page 55

Refer to the Command-Line Options and the Interactive Mode
Commands sections in Chapter 3 for help.
Refer to the Command-Line Options and the Interactive Mode
Commands sections in Chapter 3 for help.
Refer to the Interactive Mode Commands section in Chapter 3 for
help.
System error codes are usually a string of messages generated by
your operating system.
System error codes are usually a string of messages generated by
your operating system.
Reissue the Reset command with the –c option, or cycle power to the
XChecker cable and then issue the Reset command with the –c
option. See the Improper or Unstable V
No cable has been recognized at any port. Make sure there is power
to your board and to the XChecker cable. If you are using the test
fixture, you must connect V
draws power from your target system, not from your host computer.
Also make sure the RS-232 connector is firmly attached.
Refer to the XChecker Hardware section in Chapter 3 for help.
Refer to the XChecker Hardware section in Chapter 3 for help.
Cycle power to the cable. Use the Reset command with the –c option.
EZTag User Guide
Error 033: Invalid option selected option.
Error 034: Invalid value given to parameter.
Error 035: Value is required for command entered.
Error 050: System Error Messages
Error 051: System file error code.
Error 101: Cable is not initialized.
Error 102: Cable is not located.
Error 103: Invalid port name.
Error 104: Invalid baud specified.
Error 105: Cable is not reset.
section in Chapter 3.
CC
and ground to it. The XChecker cable
CC
Error Messages
A-3