Table of Contents
Advertisement
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2.2
Convertible Top Hydraulic System
⇒ "2.2.1 Hydraulic Cylinder", page 148
⇒ "2.2.2 Hydraulic Line from Cylinder", page 148
⇒ "2.2.3 Hydraulic Pump", page 150
⇒ "2.2.4 Pump Motor", page 153
2.2.1
Hydraulic Cylinder
Removing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
– Convertible top completely removed.
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Convertible top main bear‐
ing
2 - Hydraulic cylinder
❑ Remove securing
spring -4- from pins -3-
on piston rod and cylin‐
der.
❑ Remove pins sideways
from main bearing and
remove cylinder.
❑ Remove supply and re‐
turn line from cylinder.
❑ After installing, check oil
level at hydraulic pump,
add hydraulic oil if nec‐
essary.
3 - Securing pins
4 - Securing spring
❑ Release and slide side‐
ways off securing pins
2.2.2
Hydraulic Line from Cylinder
Removing
Caution
Sealing rings must always be replaced.
148
Rep. Gr.61 - Convertible Top
Advertisement
Table of Contents
