Table of Contents
Advertisement
2.2.4
Inner Cover
Removing
– Remove bumper. Refer to
⇒ "2.2.1 Front Bumper", page 170
– Release retaining tabs -1- and remove inner cover -2-
-arrow-.
Installation
Install in reverse order of removal. Note the following:
– The retaining tabs must engage completely.
– Install the bumper. Refer to
⇒ "2.2.1 Front Bumper", page 170
2.2.5
Spoiler Upper Part
Removing
– Remove the bolts -2- and -3-.
– Remove spoiler upper part -1- on the outside starting at the
bumper -arrows-.
Installation
•
For the correct tightening specifications, refer to
⇒ "1.2.1 Front Bumper Assembly Overview", page 156
Install in reverse order of removal. Note the following:
– During installing, the retaining tabs must engage completely
in the bumper.
2.2.6
Spoiler Lower Part
Removing
– Remove the bolts -1-.
– Remove spoiler lower part -2- on the outside starting at the
bumper -arrows-.
Installation
•
For the correct tightening specifications, refer to
⇒ "1.2.1 Front Bumper Assembly Overview", page 156
Install in reverse order of removal. Note the following:
– During installing, the retaining tabs must engage completely
in the bumper.
.
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
.
with respect to the correctness of information in this document. Copyright by AUDI AG.
.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2. Removal and Installation
173
Advertisement
Table of Contents
