Table of Contents
Advertisement
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
– In the illustration show (min marking on window side), window
is adjusted correctly when both contact surfaces -a- and -b-
contact the door window and the contact surface on the roof
trim molding shows a small gap.
– If the upper contact surface -a- does not make contact with the
door window, the window is adjusted to far inward.
– In the illustration shown (max marking on window side), the
window is adjusted correctly when the contact surfaces makes
contact with the roof trim molding and the upper contact sur‐
face -a- of the template shows a small gap.
– If the contact surface of the template does not make contact
with the roof trim molding, the door window is too far out.
Height adjustment
– Apply a marking to an adhesive strip -2- at a distance of -a- =
17 mm, measured from the upper edge of the door window.
– Position template as shown and slide upward as far as the stop
on the roof trim strip -1-.
– When adjusted correctly, the marking must be located in the
area of the small grading as shown.
74
Rep. Gr.57 - Front Doors, Central Locking System
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Advertisement
Table of Contents
