Table of Contents
Advertisement
Hydraulic Line, Removing from Pump
Caution
O-ring seals should always be replaced after removal.
1 - Bolt
❑ 6 Nm
2 - Hydraulic line
❑ Raise hydraulic pump
out of housing.
❑ To remove, remove se‐
curing bolt -1- and re‐
move connector pieces
with hydraulic line from
pump block -4-.
❑ Before installing, slide
new O-ring seals onto
connecting pieces.
Caution
When
inserting,
necting pieces must lie
flush before bolts are
tightened.
❑ To install, slide connect‐
ing pieces completely
into pump block and
tighten securing bolts
-1- to 6 Nm.
3 - Oil reservoir
❑ With »Min« and »Max«
markings.
❑ Oil level must be be‐
tween markings.
4 - Pump block
5 - Motor for hydraulic pump
6 - Noise Insulation
7 - Hydraulic pump housing
Oil Reservoir, Replacing
con‐
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2. Removal and Installation
151
Advertisement
Table of Contents
