Minimum Curing Times; Adhesive Sealant, Removing From Window; Paint Surfaces; Windshield, Removing - Audi TT 207 Repair Manual

Materials
♦ Cutting cord -357 853 999-
♦ Cutting cord -357 845 955-
1) Observe minimum curing time.
2) Double cartridge pistol -VAS 5237- must be used to process this material.
3) Heat according to manufacturer instructions using cartridge heater -V.A.G 1939 A- .
4) Small cartridge (110 ml) for sealing and/or when a 400 ml double cartridge is not sufficient.

Minimum Curing Times

WARNING
♦ For safety reasons, use only electrically non-conductive
2C-adhesive when installing windshield and rear window
using the materials listed below.
♦ The vehicle can only be used after the minimum curing
time has elapsed.
Window type
Windshield
Rear lid Coupe
Side windows

Adhesive Sealant, Removing from Window

Using adhesive remover -D 002 000 10- is recommended. Always
follow the safety precautions when using adhesive remover.
Caution
When cleaning from vehicle interior out, the window just in‐
stalled must not be pressed outward.

Paint Surfaces

– Clean the painted surface with a dry cloth. Clean off any dirt
with adhesive remover -D 002 000 10- .
Plastic Trim
– Allow the adhesive sealant to harden (approximately 1 hour)
and then peel it off.
2.1.2 Windshield

Windshield, Removing

– Remove windshield wiper arms. Refer to ⇒ Electrical Equip‐
ment; Rep. Gr. 92 ; Removal and Installation .
– Remove cowl panel trim.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Vehicle Adhesive sealing material
with/without 2K Window Adhesive Kit -DA 004
airbag
2K Window Adhesive Kit -DA 004
1K window adhesive -DH 009
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
Curing time in hours
600 A2-
600 A2-
100 03-
2. Removal and Installation
3
3
3
197