Audi TT 207 Repair Manual page 156

Audi TT 2007 ➤
Body Exterior - Edition 11.2010
1 - Oil reservoir
❑ Before removing, first
loosen filler plug -2- to
bleed.
❑ To remove, loosen bolt
-7- on clamp until oil res‐
ervoir can be removed
from pump block.
❑ Then pull oil reservoir off
of pump block, alternat‐
ing sides.
❑ Always replace O-ring
seals.
❑ Before install, first loos‐
en filler plug -2- to bleed.
❑ When installing, slide oil
reservoir on to the first
retainer.
❑ Then slide oil reservoir
in the correct position
completely onto pump
block.
❑ The oil reservoir then
engages in the pump
block.
❑ O-ring seal must lie
cleanly in the intended
groove.
❑ After checking, slide on
clamp -6- and tighten
bolt -7- to the specifica‐
tion.
2 - Oil filler screw
Note
❑ 5 Nm
3 - Emergency operation valve
❑ 2 Nm
4 - Pump block
5 - Motor for hydraulic pump
6 - Clamp
7 - Bolt
❑ 4 Nm
8 - Oil level marking
152
Rep. Gr.61 - Convertible Top
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.