Audi TT 207 Repair Manual page 189

– Remove spoiler -2- on lower trim -1- -arrows-.
Installation
• For the correct tightening specifications, refer to
⇒ "1.4.1 Rear Bumper Assembly Overview", page 160
Install in reverse order of removal. Note the following:
– The spoiler and the lower trim must engage completely.
– Install the diffuser trim. Refer to
⇒ "2.4.3 Diffuser Trim", page 185
2.4.3 Diffuser Trim
Removing
– Remove the bolts -1- and -3-.
– Remove diffuser trim -2- -arrows-.
Installation
• For the correct tightening specifications, refer to
⇒ "1.4.1 Rear Bumper Assembly Overview", page 160
Install in reverse order of removal. Note the following:
– The diffuser trim must engage completely.
2.4.4 Exhaust Pipe Trim
Removing
– Remove the rear bumper. Refer to
⇒ "2.4.1 Rear Bumper", page 182
– Remove the bolts -arrows-.
– Remove the exhaust pipe trim -1- inward from the bumper
cover.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Installation
• For the correct tightening specifications, refer to
⇒ "1.4.1 Rear Bumper Assembly Overview", page 160
Install in reverse order of removal. Note the following:
– Check the distance of exhaust pipe trim -2- from bumper cover
-1-:
• Dimension -x- = uniform gap.
– Install the rear bumper. Refer to
⇒ "2.4.1 Rear Bumper", page 182
.
.
.
.
.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2. Removal and Installation
185