Rear Lid Stop Buffer - Audi TT 207 Repair Manual

2 - Rubber stop
❑ If lid is adjusted correctly, stop buffers must lightly contact body when lid is closed.
3 - Pop rivet
❑ To remove, drill out rivet head and drive out rivet shaft.
4 - Rear lid lock
❑ To remove, remove combi-bolts and disengage cable.
5 - Nuts
❑ 21 Nm
6 - Cable for emergency release
7 - Striker
❑ Adjusting:
– Tighten combi-bolts
– Carefully close the rear lid so that it is flush with the side panels.
– Carefully open lid and tighten bolts
8 - Nuts
❑ 21 Nm
9 - Protective film
❑ Self-adhesive.
❑ Remove protective paper before applying.
10 - Rear lid hinge
❑ Removing and installing
2.3.2

Rear Lid Stop Buffer

– Close the rear lid.
Note
If lid is adjusted correctly, stop buffers must lightly contact body
when lid is closed.
– The replacement buffers are pre-adjusted and are moved out
or in only when needed.
– Check gap dimensions
Note
To remove stop buffer, drill out rivet head -1-, drive out rivet shaft
and remove buffer.
⇒ Item 5 (page 51) by hand (it must still be possible to slide striker).
⇒ Item 5 (page 51)
⇒ "2.3.3 Rear Lid Hinge", page 52
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ page 18 .
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
.
.
2. Removal and Installation
51