Door Seals; Special Tools And Workshop Equipment Required; Coupe Inner Door Seal - Audi TT 207 Repair Manual

Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2.1.2

Door Seals

Special tools and workshop equipment required

♦ Roller -3356-
♦ Adhesive strip remover -VAS 6349-
Roadster Inner Door Seal
Note
The inner door seal is glued on and must be replaced.
♦
Adhesion surfaces must be free of dust and grease.
♦
Both the vehicle and the seal must be room temperature.
♦

Coupe Inner Door Seal

1 - Door seal
• Removing and installing
with lower A-pillar trim, sill
trim and B-pillar trim re‐
moved. Refer to ⇒ Body
Interior; Rep. Gr. 70 ; Re‐
moval and Installation .
❑ Removing
– Remove door seal all
around from flange or
from upper seal guides
and side window.
❑ Installing:
– First press door seal into
seal guide at upper B-
pillar -arrow-.
– Then press door seal in‐
to seal guide at upper A-
pillar -arrow-.
– First press door seal into
seal guide at center of
door frame, then along
the entire length.
– Press bottom of door
seal onto side window
seal guide.
– Then, beginning at cen‐
ter and working out,
press door seal com‐
pletely into seal guide in
the side window area.
– Press door seal onto
door flange at lower B-
pillar.
– Then press door seal on between side window and lower B-pillar, beginning at center and working out.
– Press door seal onto door flange at lower A-pillar.
82
Rep. Gr.57 - Front Doors, Central Locking System
⇒ page 83
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.