Table of Contents
Advertisement
Seal, Adjusting
– For side adjustment, slide in shims -3- between guide rails and
convertible top guide -2- appropriate to the door window.
– Tighten bolts -1- on guide rails to the specification.
2.1.7
Convertible Top Frame Flap
1 - Trim
❑ Is clipped to flap.
❑ Flap, releasing, refer to
⇒ page 126
2 - Convertible top frame cover
❑ To adjust, loosen bolts
-4- on body and adjust
flap so it is flush with
convertible top.
❑ Height adjustment to
side panel
⇒ page 126
❑ Panel gap dimensions
⇒ page 126
3 - Push rod
Caution
During convertible top
emergency
operation,
push rod must first be
disconnected at upper
ball stud -arrow- and
valve bolt on hydraulic
pump
⇒ page 115
be opened.
4 - Bolt
❑ 5 Nm
5 - Window
6 - Body flange
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
must
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2. Removal and Installation
125
Advertisement
Table of Contents
