Audi TT 207 Repair Manual page 31

Note
2 - Screws
❑ 32 Nm
3 - Hood hinge
• For removal and installation, the hood must be removed or supported securely.
❑ Removing
– Remove gas-filled strut
– Remove the bolts -2- and nuts -4-.
❑ Installation: in reverse order.
4 - Nuts
❑ 25 Nm
5 - Gas strut
❑ Removing and installing, refer to
❑ The gas-filled strut tube is installed on the hood side.
6 - Ball stud
❑ 21 Nm
7 - Protective film
❑ Self-adhesive.
❑ Remove protective paper before applying.
8 - Nuts
❑ 9 Nm
9 - Catch
2.1.2 Hood Catch
Removing
– Remove nuts and remove catch.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ "2.1.5 Gas-Filled Strut", page 30
⇒ "2.1.5 Gas-Filled Strut", page 30
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
.
.
2. Removal and Installation
27