Table of Contents
Advertisement
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
1.1.3
Side Window Assembly Overview
1 - Side Window
❑ When installing, press in
window with securing
pin at »C-pillar«, then in‐
sert in window opening
and secure with pop riv‐
ets in »B-pillar« area.
❑ If a removed window is
reinstalled, window
must be secured to »C-
pillar« with adhesive
tape.
2 - Pop rivet
❑ To remove side window,
drill out rivet heads and
drive out rivet shafts.
3 - Retaining clip
4 - Roof trim molding
❑ Before roof trim molding
can be removed from
the clips, pop rivets in
upper door area must
first be removed. Refer
to
⇒ "3.1.1 Roof Trim
Molding", page 227
5 - Securing pin
❑ No replacement part
❑ Is cut through during
window removal
1.1.4
Rear Window Assembly Overview
WARNING
When removing a window, always wear protective eyewear
and leather gloves.
192
Rep. Gr.64 - Glass, Window Regulators
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Advertisement
Table of Contents
