Table of Contents
Advertisement
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
2.1.5
Gas-Filled Strut
1 - Gas strut
❑ To remove securing
spring -arrow-, raise
slightly and remove gas-
filled strut from ball stud.
Note
2 - Hood
3 - Ball stud
❑ 21 Nm
Removing
– Support the hood or secure it against falling.
– Raise securing spring slightly using a small screwdriver and
remove gas-filled strut -1- from upper ball stud -2-.
– Repeat procedure on lower ball stud.
Installation
Note
After complete removal of the gas-filled strut ensure correct po‐
sitioning during installation: the gas-filled strut tube must be at‐
tached on the hood side.
– Press gas-filled strut onto ball stud and engage.
30
Rep. Gr.55 - Hood, Lids
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Advertisement
Table of Contents
