5
Prepare the Vivo 3 for Use
5.1
Checking the Vivo 3 before First Use
Before using the Vivo 3, perform the following checks.
1
Ensure that the equipment is in good condition.
2 If stored more than 1 month, connect the Vivo 3
to the power supply to recharge the internal battery.
3 Check that the air inlet filters are installed.
5.2
Placing the Vivo 3
WARNING!
Read the chapter 2.3 Environment — Warnings and Precautions, page 12 carefully to make
sure all conditions are met and considered.
1
Place the Vivo 3 on a solid, flat surface. The
Vivo 3 should be placed lower than the patient in
order to prevent the device from falling on the patient,
as well as preventing condensed water from reaching
the patient.
2 Make sure that nothing can block the patient air
inlet at the back of the Vivo 3, such as a curtain etc.
3 Make sure that the controls are accessible for the
operator.
5.3
Connecting the Vivo 3 to Power Supply
This chapter describes how to connect a Breas power supply.
WARNING!
Read the chapter 2.2 Electricity — Warnings and Precautions, page 11 carefully to make sure
all conditions are considered and met.
CAUTION!
Isolation from external power sources is provided by the approved AC/DC and DC/DC
adapters. The ventilator must only be powered by the approved accessories, see .
36 Prepare the Vivo 3 for Use
User Manual
Doc. 007231 F-3