Figure 15-7
Changes in orientation
Based on the above observations, a different behavior also results when the orientation of the
machining head is changed while the clearance control is active.
In the following diagram the normal case is shown on the left (compensation vector == tool
orientation vector); and the case with the programmed compensation vector is shown on the
right.
Figure 15-8
Change in orientation of the machining head
Special functions
Function Manual, 01/2015, 6FC5397-2BP40-5BA2
Programmable compensation vector
TE1: Clearance control - 840D sl only
15.2 Clearance control
571