M17
Program changes
By changing the content of the RESU-specific subroutine "CC_RESU_BS_ASUP.SPF", the
user (machine manufacturer) takes over the responsibility for the correct sequence of the
technological function.
Note
CC_RESU_BS_ASUP.SPF may be changed.
User-specific modifications must be inserted before the part program block RMN.
19.5.6
RESU ASUB (CC_RESU_ASUP.SPF)
Function
The RESU-specific ASUB "CC_RESU_ASUP.SPF" is required internally for the function. The
ASUB is initiated if the following RESU interface signal is switched over in the NC stop state:
DB21, ... DBX0.1 (Forward/Reverse)
Program structure
CC_RESU_ASUP.SPF has the following content:
PROC CC_RESU_ASUP
M17
Note
CC_RESU_ASUP.SPF must not be changed.
Special functions
Function Manual, 01/2015, 6FC5397-2BP40-5BA2
TE7: Continue machining at the contour (retrace support) - 840D sl only
CAUTION
; siemens system asub - do not change
G4 F0.001
M0
REPOSA
19.5 RESU-specific part programs
717