Siemens SINUMERIK 840D sl Function Manual page 402

M3: Coupled axes
8.5 Generic coupling
Example:
Programming
CPLOUTTR[X2,X1]=100
Scaling of the output value
Syntax:
Designation:
Functionality:
Value:
Example:
Programming
CPLOUTSC[X2,X1]=3
Note
The following setting data used in the existing coupling type "Master value coupling" is
considered in generic coupling independently of the set coupling type (CPSETTYPE):
SD43102 $SA_LEAD_OFFSET_IN_POS[FAx] (offset of master value)
SD43104 $SA_LEAD_SCALE_IN_POS[FAx] (scaling of master value)
SD43106 $SA_LEAD_OFFSET_OUT_POS[FAx] (offset of function value of the curve table)
SD43108 $SA_LEAD_SCALE_OUT_POS[FAx] (scaling of function value of the curve table)
These setting data have the following effect:
● on all leading axes that are coupled with the following axis via a curve table. This must be
taken into account for couplings with more than one leading axis!
● in addition to the CP key words CPLINTR, CPLINSC, CPLOUTTR and CPLOUTSC.
402
Default value: 0
Comment
; The output value of the coupling of the following axis
X2 with leading axis X1 is displaced by the value 100 in
the positive direction.
CPLOUTSC[FAx,LAx]= <value>
Coupling Lead Out Scale Factor
Defines the scaling factor for the output value of coupling the following
axis FAx with leading axis LAx.
Type: REAL
Default value: 1
Comment
The output value of the coupling of the following axis X2
with leading axis X1 is multiplied with factor 3.
Function Manual, 01/2015, 6FC5397-2BP40-5BA2
Special functions