Siemens SINUMERIK 840D sl Function Manual page 553

Interface versions
The relevant interface versions are displayed under:
● Interface version of the NCK system software
HMI Advanced:
Diagnosis > Service Display > Version > NCU Version
Display (excerpt)
-------------------------------------------
CC Interface Version:
@NCKOPI . . . .@Interfaces=<
Loaded Compile Cycles:
. . . .
-------------------------------------------
● Interface version of a compile cycle that has not yet been loaded
HMI Advanced (excerpt):
Services > <
Display:
-------------------------------------------
Contents: Loadable compile cycle
Interface: . . . . @Interfaces=<
-------------------------------------------
● Interface version of a loaded compile cycle
HMI Advanced:
Diagnosis > Service Display > Version > NCU Version
Display (excerpt)
-------------------------------------------
CC Interface Version:
@NCKOPI . . . .
Loaded Compile Cycles:
<
CC start address
_N_<
-------------------------------------------
Example:
_N_CLC407IF003001_ELF corresponds to interface version: 3.1
Dependencies
The following dependencies exist between the interface versions of a compile cycle and the
NCK system software:
● 1. Position of the interface version number
The 1st digit of the interface version number of a compile cycle and the NCK system
software must be the same .
● 2. Position of the interface version number
The 2nd digit of the interface version number of a compile cycle must be less than or
equal to the 2nd digit of the NCK system software.
Note
If alarm 7200 is displayed after powering-up, this means no compile cycle has been loaded!
Special functions
Function Manual, 01/2015, 6FC5397-2BP40-5BA2
Medium > > Softkey: "Properties"
Identifier > < Version > < Generation Data >
Identifier >< Version >IF< 1st digit >< 2nd digit >_ELF . . .
TE01: Installation and activation of loadable compile cycles
1st digit >.< 2nd digit > . . . .
1st digit >.< 2nd digit > . . . .
13.2 Interface version compatibility
553