Switches; Power On/Off Slide Switch - Xilinx ZC702 User Manual

Switches

[Figure 1-2, callout 22–26]
The ZC702 board includes a power and a configuration switch:
• Power On/Off slide switch SW11 (callout 26)
• SW4 (FPGA_PROG_B), active-Low pushbutton (callout 22)

Power On/Off Slide Switch

[Figure 1-2, callout 20]
The ZC702 board power switch is SW11. Sliding the switch actuator from the Off to On
position applies 12V power from J60, a 6-pin mini-fit connector. Green LED DS14
illuminates when the ZC702 board power is on. See
onboard power system.
Do NOT plug a PC ATX power supply 6-pin connector into J60 on the ZC702 board. The ATX
CAUTION!
6-pin connector has a different pinout than J60. Connecting an ATX 6-pin connector into J60 damages
the ZC702 board and voids the board warranty.
Figure 1-26 shows the power connector J60, power switch SW11 and indicator LED DS14.
X-Ref Target - Figure 1-26
J60
12V
12V
N/C
N/C
COM
COM
ZC702 Board User Guide
UG850 (v1.7) March 27, 2019
SW11
VCC12_P_IN 2
1
4
2
5
5
3
6
INPUT_GND
INPUT_GND
Figure 1-26: Power On/Off Switch SW11
www.xilinx.com
Power Management
U78
1
3
1
4
6
C512
1μF
25V
3
Feature Descriptions
for details on the
VCC12_P
8
C517 R387
330μF 1kΩ
1%
25V
7
DS14
6
5
GND GND
UG850_c1_26_030513
Send Feedback
51