Operation Behaviour = Actuator Behaviour Definition; Intermediate Positions: Set The Signalling - AUMA AUMATIC AC 01.1 Manual

Actuator controls
AUMATIC AC 01.1/ACExC 01.1 Profibus DP

7.4.4 Operation behaviour = actuator behaviour definition

7.4.5 Intermediate positions: set the signalling

50
The reaction of the actuator upon reaching an intermediate position can be
programmed via the parameters "
BEHAVIOUR.
Æ
Via the menu to parameter:
MAIN MENU (M0)
SETTINGS (M1)
INTERMED. POSITION (M1C)
EDIT
POS.1 BEHAVIOUR
NO STOP

¿:OK C:ESC
‚ :EDIT
Default value:
È
Description of the parameter settings:
NO STOP
No intermediate stop, actuator continues the operation.
STOP OPENING DIR.
Actuator stops during operation in direction OPEN upon having reached the
intermediate position. Actuator only runs after a new operation command is
issued.
This function is not active in the operation mode SETPOINT MODE.
STOP CLOSING DIR.
Actuator stops during operation in direction CLOSE after reaching the inter-
mediate position. Actuator only runs after a new operation command is
issued.
This function is not active in the operation mode SETPOINT MODE.
STOP BOTH DIR.
Actuator stops after reaching the intermediate position. Actuator only runs
after a new operation command is issued.
This function is not active in the operation mode SETPOINT MODE.
.
.
The reaching of an intermediate position can be signalled:
.
via bus (see separate operation instructions)
via the indication lights (LEDs) of the local controls (page 19) or
via the output contacts (page 27)
The signal behaviour of the individual intermediate positions is set via the
POS.1-8 control parameters:
Æ
Via the menu to parameter:
MAIN MENU (M0)
SETTINGS (M1)
INTERMED. POSITION (M1C)
EDIT
POS.1 CONTROL
NOT USED

¿:OK C:ESC
‚ :EDIT
Default value:
POS. 1: BEHAVIOUR
POS.1 BEHAVIOUR (M1C11)
M1C11
NO STOP
POS.1 CONTROL (M1C13)
M1C13
NOT USED
Manual
to POS. 8: