Manual
8
Corrective action
8.1
Fault indications and warning indications
8.1.1 Status indication S0 – faults and warnings
Faults interrupt or prevent electrical actuator operation.
Warnings have no influence on the electrical actuator operation. They only
serve information purposes.
Fault and warning indications are shown on the display.
Table of contents:
8.1.1 Status indication S0 – Faults and warnings
8.1.2 Status indication S1 – Faults
8.1.3 Status indication S2 – Warnings
For further status indications in the display, refer to page 15 et seqq.
Line 4 of status indication
LOCAL MODE
OPEN
E2
FAULT IND.
È
Description of the fault indications:
FAULT IND.
A fault has occurred
Ò For further information, press
WARNING IND.
A warning has occurred
Ò For further information, press
FAULT + WARNING
Faults as well as warnings have occurred.
Ò For further information, press
(faults) or
(warnings).
S2
NOT READY IND.
The actuator cannot be operated from REMOTE. The actuator can only be
operated via the local controls.
Ò For further information, press
(cause of fault signals).
FLT + NR
Faults and the
NOT READY IND.
Ò For further information, press
S3.
WRN + NR
Faults and the
NOT READY IND.
Ò For further information, press
S3
.
FLT + WRN + NR
Faults, warnings, and the
Ò For further information, press
S3
.
AUMATIC AC 01.1/ACExC 01.1 Profibus DP
S0
shows faults and warnings.
S0
100%
qp
and go to status indication
qp
and go to status indication
qp
and go to status indication
qp
and go to status indication
signal have occurred.
qp
and go to status indications
signal have occurred.
qp
and go to status indications
signal have occurred.
NOT READY IND.
qp
and go to status indication
Actuator controls
S1
.
.
S2
S1
S3
or
S1
or
S2
S1
to
91