Led Screen Color; Output Frame Rate; Layer Settings - NovaStar VX1000 User Manual

5.2.6 LED Screen Color

This function allows you to adjust the color temperature and Gamma value of the LED screen to make the
images displayed on the screen more clear and vivid.
On the main menu screen, go to Screen Configuration > More Settings > LED Screen Color to enter the
screen color settings screen.

Select Gamma and press the knob to confirm. Rotate the knob to adjust the Gamma value and press the
knob to confirm when you are satisfied with it.

Rotate the knob to select Temperature and press the knob to confirm. Rotate the knob to adjust the
temperature mode, including Standard, Cool, Warm and Custom, and then press the knob to confirm
when you are satisfied with it.
When Custom is selected, you can customize the color temperature by adjusting the R, G and B values
individually.
Figure 5-9 LED screen color
Table 5-1 LED color parameter descriptions
Parameter
Gamma
Temperature

5.2.7 Output Frame Rate

This function allows you to set the frame rate of the output. The frame rate defaults to 60 Hz.
On the main menu screen, go to Screen Configuration > More Settings > Output Frame Rate. Rotate the
knob to select the desired frame rate and press the knob to confirm.
The supported frame rates include 23.98 Hz, 24 Hz, 25 Hz, 29.97 Hz, 30 Hz, 47.95 Hz, 48 Hz, 50 Hz, 59.94
Hz, 60 Hz, 72 Hz, 75 Hz, 85 Hz, 100 Hz and 120 Hz.

Layer Settings

The VX1000 supports three layers. The layer properties and settings are shown in
Table 5-2 Layer properties
Menu
Status
Input source
www.novastar.tech
Description
Adjust the image distortion degree from the input to output. The greater the value is, the
more distorted the image will be.
The value ranges from 0.25 to 4.00 and defaults to 2.8.
Adjust the cool or warm degree of images displayed on the LED screen. When Custom is
selected, you can customize the color temperature by adjusting the R, G and B values
individually.
Description
Open or close the layer.
The main layer is opened and two PIP layers are closed by default.
Select an input source for the current layer.
VX1000 All-in-One Controller User Manual
Table 5-2.
15