Layer Settings; Layer; Layer Properties - NovaStar NovaPro UHD User Manual

5.4 Layer Settings

5.4.1 Layer

5.4.1.1 Layer Properties

Figure 5-7 Layer properties
Menu
Select Layer
Status
Input Source
Layer Adjust
Priority
Input Crop
www.novastar.tech
Description
Select the desired layer. At most 6 layers are supported.
Note:
Press a number button in the LAYER area on the device front panel to enter the layer
settings screen and open the selected layer.
Open or close the layer.
Select the input source for the selected layer.
Note:
Press an input source button in the SOURCE area on the device front panel to quickly
select an input source for the layer.
Adjust the aspect ratio, size and other parameters of the layer.
Aspect Ratio: Set the proportional relationship between the layer's

width and height.
The options are 1:1, 5:4, 4:3, 3:2, 16:9, 16:10 and Custom.

Keep Ratio: Keep the aspect ratio.

H Width: The range is 64 - 8192 and the default value is 800.

V Height: The range is 64 - 8192 and the default value is 600.

Initial X: Set the horizontal initial coordinate of the layer.

Initial Y: Set the vertical initial coordinate of the layer.

Full Screen: Make the layer display in full screen.

Reset: Reset all the settings to defaults.

Set the layer display order. The range is 1 - 6.
1: The layer is at the bottom.

6: The layer is on the top.

Crop the input source image and make the part after cropping display in full screen.
Status: Turn on or turn off this function for the selected layer.

H Width: The horizontal width of the current input source. The range is

64-horizontal width of the input source.
V Height: The vertical height of the current input source. The range is 64-

vertical height of the input source.
Initial X: The horizontal initial coordinate of the part after cropping upon

NovaPro UHD All-in-One Controller User Manual
6