Set Layer Scaling (All-In-One Controller Mode) - NovaStar CX40 Pro User Manual

Figure 6-10 Sync
Select the desired sync source from the listed ones.

Active Source: Sync with the frame rate of the active source.

Genlock: Sync with the frame rate of the Genlock signal.

Internal: Sync with the frame rate of the controller's internal clock.
Select Phase Offset.
Select an adjustment method from the listed options and press the knob.

Off: Turn off the phase offset function.

Angle: The related parameter Angle can be set.

Fraction: The related parameter Fraction can be set.

Absolute: The related parameters Lines and Pixels can be set when the sync source is Active Source.

6.5 Set Layer Scaling (All-In-One Controller Mode)

When the working mode is All-In-One Controller, the canvas size and the layer (currently only 3 layers supported) on
the canvas can be set.
Select the Layer menu from the main menu.
Figure 6-11 Layer settings
Select Canvas Resolution, enable the value editing status, rotate the knob to adjust the value and press the knob to
confirm it.
Select a layer, press the knob to open the editing page, and set the related parameters.
www.novastar.tech
CX40 Pro LED Display Controller User Manual
21