Set Object - ABB PFEA 111 User Manual

3.12.2 Set Object

WebTension
> 5 s
FastSetUp
Presentation-
Menu
SetObject
NominalLoad
ZeroSet
SetWrapGain
VoltageOutput
CurrentOutput
Miscellaneous
Menu
ServiceMenu
3BSE029380R0101 Rev C
From PresentationMenu
SetObject
ZZ
To NominalLoad
Figure 3-4. Set Object Menus
Use up and down keys to select type of object
There are three object types that can be selected.
• Standard roll (if both load cell A and B are connected to the roll)
Standard roll
Two load cells with separate signals
B A
Figure 3-5. Object Type Standard Roll
• Single Side A measurement (if only load cell A is connected to the roll)
Single Side A measurement
One load cell signal
A
Figure 3-6. Object Type Single Side A measurement
• Single Side B measurement (if only load cell B is connected to the roll)
Single Side B measurement
One load cell signal
B
Figure 3-7. Object Type Single Side B measurement
When Single Side A or Single Side B measurement is selected the measured signal is multiplied
by two and presented as web tension on display and analog output.
Tension Electronics PFEA111/112, User Manual
AreYouSure
[ZZ] from list
PFEA111/112
Signal input
A
B
PFEA111/112
Signal input
A
PFEA111/112
Signal input
B
Section 3.12.2 Set Object
SetObject
[ZZ]
.
3-13