ABB PFEA 111 User Manual page 2

This publication includes, DANGER, WARNING, CAUTION and NOTE information where appropriate to point out safety
related or other important information.
DANGER Hazards which could result in severe personal injury or death
WARNING Hazards which could result in personal injury
CAUTION Hazards which could result in equipment or property damage
NOTE Alerts user to pertinent facts and conditions
Although DANGER and WARNING hazards are related to personal injury, and CAUTION hazards are associated with
equipment or property damage, it should be understood that operation of damaged equipment could, under certain operational
conditions, result in degraded process performance leading to personal injury or death. Therefore, comply fully with all
DANGER, WARNING, and CAUTION notices.
The information in this document is subject to change without notice and should not be construed as a commitment by ABB AB.
ABB AB assumes no responsibility for any errors that may appear in this document.
In no event shall ABB AB be liable for direct, indirect, special, incidental or consequential damages of any nature or kind
arising from the use of this document, nor shall ABB AB be liable for incidental or consequential damages arising from use of
any software or hardware described in this document.
This document and parts thereof must not be reproduced or copied without ABB AB's written permission, and the contents
thereof must not be imparted to a third party nor be used for any unauthorized purpose.
The software described in this document is furnished under a license and may be used, copied, or disclosed only in accordance
with the terms of such license.
The Tension Electronics PFEA111/112 fulfills the requirements as stated in the RoHS Directive 2011/65/EU, EMC Directive
2014/30/EU and Low Voltage Directive 2014/35/EU, the provided that the installation is carried out in accordance with the
installation instructions given in
The Tension Electronics PFEA111-20, PFEA111-65 and PFEA112-20 fulfill the requirements of safety approval for USA and
Canada according to the standard UL61010C-1 for Process Control Equipment and CSA C22.2 No. 1010-1 Safety
Requirements for Measurement, Control and Laboratory Use, Part 1: General Requirements Certificate No. 170304-E240621
and No. 240504-E240621, provided that the installation is carried out in accordance with the installation instructions given in
Chapter 2 Installation, included in this User Manual.
Copyright  ABB AB, 2004-2018.
Use of DANGER, WARNING, CAUTION, and NOTE
TRADEMARKS
®
Pressductor is a registered trademark of ABB AB.
CE-MARKING
Chapter 2 Installation, included in this User Manual.
NOTICE
Template: 3BSE001286/D
3BSE029380R0101 Rev C