Using The Panel Buttons; Navigating And Confirming; Changing Numerical Values And Parameters - ABB PFEA 111 User Manual

Tension Electronics PFEA111/112, User Manual
Chapter 3 Commissioning

3.4 Using the Panel Buttons

3.4.1 Navigating and Confirming

3.4.2 Changing Numerical Values and Parameters

3-2
Display
Power
Set language
[English]
SetTensionAt10V
XXXXXX N
• X indicates a numerical value.
• Z indicates that a parameter can be chosen from a list.
SetTensionAt10V
[XXXXXX] N
To change a numerical value, X, or parameter, Z, press
then placed within brackets [XXXXXX] or [ZZ] to show that it can be changed.
If it is a "Z" parameter, use
shown on the display press
brackets around the value disappear.
If you have pressed so that the parameter is placed within brackets, you can cancel the
entering mode by pressing
stored. If is pressed the old value is displayed without brackets.
To change a numerical value, press
digit can be changed with
the second digit can be changed with
been set, the new value is saved and displayed without brackets.
Using when entering a numerical value means returning to the previous digit. By pressing
a sufficient number of times you will leave the entering mode and the old value will be
displayed without brackets.
Button How to use it
Steps back to previous menu.
Sometimes you must press this button
two or more times to get back to the
Status
desired menu.
Steps up in a list.
Steps down in a list.
Steps to next main menu.
OK (acknowledgment) button. Confirms
a selection or a parameter setting.
NominalLoad
ZZ kN ZZ lbs
NominalLoad
[ZZ kN ZZ lbs]
and to go up or down in the list. When the desired value is
. When is pressed the new parameter value is saved and the
. The selections you have done with
so that the value is placed within brackets. Then the first
and . When the first digit has the desired value press
and . When pressing
. The numerical value or parameter is
and will not be
after the last digit has
3BSE029380R0101 Rev C
, then