Table of Contents
Advertisement
4.4
Replacing the media core
4.4
Replacing the media core
This section describes how to replace the media core of Roll Winder RW-210.
-
To replace the media when the print job is finished
-
To replace the media when the winding diameter reaches the maximum value 500 mm / 19.69"
-
To replace the media when removing the media wound being misaligned
NOTICE
Before taking the media from Roll Winder RW-210, make sure that this machine is stopped.
4.4.1
Set the media core to the rewinder spindle
Before setting the media core to the rewinder spindle, prepare the following items.
-
Scissors
-
Masking tape (more than 30 mm / 1.18" in width)
-
Ruler
-
Lifter
1
Press [Stop] on the "Run" screen on the touch panel.
The "Stop" screen is displayed.
Be sure to switch to the "Stop" screen before making the operation.
AccurioLabel 230
4
4-29
Advertisement
Table of Contents
