Table of Contents
Advertisement
4.6
Additional printing on the media with eye mark printed
4.6.4
Confirm/change the teach-in mode
The calibration mode of ES-101 is set to dynamic teach-in.
If less than four LEDs are lighting or detection of the eye mark is unstable when the eye mark is to be checked,
change the calibration mode to two-point teach-in and confirm again.
Confirm the teach-in mode
1
Long-press the + and - buttons of ES-101 at the same time.
The mode is switched to the teach-in mode.
2
Confirm the current teach-in mode.
The teach-in mode varies depending on the lighting status of LED as follows.
3
Long-press the + and - buttons of ES-101 at the same time to return to the normal mode.
AccurioLabel 230
Dynamic teach-in
Two-point teach-in
4
4-45
Advertisement
Table of Contents
