3.3
Replacing the Media Core
3.3
Replacing the Media Core
This section describes how to replace the media core of Roll Winder RW-201.
-
To replace the media when the print job is finished
-
To replace the media when the winding diameter reaches the maximum value 500 mm / 19.69"
NOTICE
NOTICE
Before taking the media from Roll Winder RW-201, make sure that this machine stops.
Set the Media core to the Winding Shaft
Before setting the media core to the winding shaft, prepare the following items.
-
Scissors
-
Masking tape (width more than 30 mm / 1.18")
-
Ruler
-
Phillips screwdriver and other tool
-
Lifter
A
Press the REWIND MOTOR OFF on the control panel of Roll Winder RW-201.
The motor of Roll Winder RW-201 stops.
B
Open the media cover of Roll Winder RW-201.
3-20
REWIND MOTOR
REWIND MOTOR
EMG.RESET
ON
OFF
READY
JOG
STOP