Table of Contents
Advertisement
6
6.5
A media feeding error occurs
This section describes typical media errors and remedies for them.
Take an action as shown below according to each problem.
Problem
Media snakes or is mis-cen-
tered.
The media does not rotate well.
Jam code J-1714 or J-3105 is
displayed.
White spots appear on the out-
put paper.
The media wrinkles.
The media in the feeding section
goes out alignment.
A roll end error occurs.
The status of Roll Winder
RW-110/Roll Winder RW-210 is
displayed in red.
"Torque too High, reduce ten-
sion or increase taper" is dis-
played and media is not
transferred.
The message "Safety door
open" is displayed.
6-18
Remedy
1. Replace the media wound being misaligned.
2. Check the position of the media.
3. Clean adhesive sticking on the parts.
4. Adjust the media conveyance position.
5. Confirm the air pressure of the manometer.
For details, refer to page 6-19.
1. Check the position of the media.
2. Clean adhesive sticking on the parts.
3. Clear paper jams.
For details, refer to the following page.
•
For J-1714: page 6-23
•
For J-3105: page 6-24
1. Check the position of the media.
2. Clean adhesive sticking on the parts.
3. Adjust the second transfer output.
For details, refer to page 6-24.
1. Adjust the fusing speed.
For details, refer to page 6-25.
1. Check the position of the media.
2. Confirm the air pressure of the manometer.
For details, refer to page 6-25.
Roll Winder RW-110 detected roll end.
Replace the media with a new one.
1. Confirm the preparation before printing.
For details, refer to page 6-25.
1. Confirm the preparation before printing.
For details, refer to page 6-25.
Opening of the safety doors of Roll Winder RW-110 and Roll Winder
RW-210 was detected.
Close all of the safety doors.
A media feeding error occurs
AccurioLabel 230
6.5
Advertisement
Table of Contents
