Table of Contents
Advertisement
6.4
Clearing paper jams
7
Move the lever [M1] to the left, then pull out the ADU.
8
Open the cover [M2] and cover [M3] and check for adhesive sticking or paper remaining inside the
machine.
% If any adhesive sticks to the parts, clean inside the machine.
Check if adhesive peeled from the pasted part and stuck to the guide plate as well as adhesive run-
ning off the edge of the media.
% If paper remains, remove it.
% If the JAM code [J-3112] is displayed, check if the centering sensor located behind the cover [M3]
is clean.
9
Confirm that the leaf spring (back) and leaf spring (front) do not come off.
% If they come off, refer to page 5-12 and reattach them.
DO NOT put your hand into the fixing part of the fixing unit.
% Otherwise, you may get burned. Be especially careful when pulling out the fixing unit or opening
the fixing part.
AccurioLabel 230
6
6-15
Advertisement
Table of Contents
