Table of Contents
Advertisement
3.1
Before printing
Image position adjustment
You can change zoom ratio of images or shift images (forward or backward).
When printing, heat in the fixing section 18
may cause the media to slightly enlarge or shrink. How much the paper is affected depends on the type or
thickness (weight) of the paper; therefore, after changing the media, always perform the [Registration Adj.].
NOTICE
To determine the misalignment of printing position, the adjustment of the reference position required on the
main body side must be completed.
Before performing the [Registration Adj.], confirm the following adjustment items.
(1) [Feeding Direction Mag. Adjustment] -> "User's Guide [Adjustment]/[Machine Adjustment]"
(2) [CD-Mag. Adjustment] -> "User's Guide [Adjustment]/[Machine Adjustment]"
(3) [Centering Adjustment] -> "User's Guide [Adjustment]/[Machine Adjustment]"
The adjustment for the reference position of the print side is an advanced adjustment. Contact your service
representative in advance of the adjustment.
Tips
-
There are two ways for registration adjustment: One is using [Registration Adj.] on the MACHINE
screen; the other is using [Paper Setting] - [Change Set] - [Change IndividualSet] on the MACHINE
screen.
-
When the registration is adjusted in [Paper Setting] on the MACHINE screen, the adjusted value can be
registered as paper profile. You can call the registered paper profile when needed and easily make pa-
per settings.
Registration Adj.
You can use any of the following to adjust.
-
[Zoom]/[Image Shift] adjustment: The magnification and printing position in up and down directions can
be finely adjusted. The adjustment data can be entered directly in percentage terms or in numerical
terms to shift. See page 3-18.
-
[Chart Adjustment]: You can print a chart and scale measurement points. Entering the measured value
adjusts the magnification and printing position. See page 3-20.
AccurioLabel 230
3
3-17
Advertisement
Table of Contents
