Media Route - Konica Minolta AccurioLabel 230 Quick Manual

4.1

Media route

4 Handling paper
This section describes how to set, replace, adjust, and configure the media.
For details, refer to each of the following pages.
-
Media route: page 4-3
-
Setting media: page 4-4
-
Replacing the media: page 4-23
-
Replacing the media core: page 4-29
-
Splicing the media (For cleaning/clearing paper jam): page 4-33
4.1 Media route
The following diagram shows the media route. Set the media along the correct route.
NOTICE
Before setting or replacing the media, turn on the main power switch and sub power switch of the main
body, and the main power switch and sub power switch of Roll Winder RW-110/Roll Winder RW-210. For
the power operation, refer to page 2-3.
AccurioLabel 230
4
4-3