4
4.6.1
Conditions of detection of eye mark
Eye mark can be detected within the range of the paper feed width of 330 mm/12.99".
4.6.2
Install External Sensor Kit ES-101
Install External Sensor Kit ES-101 to the leading section of the main body of the printer. Install it in the
correct position aligned with the position of the eye mark.
Removing ES-101
ES-101 is installed to the upper or lower side of the leading section. When moving ES-101 from the upper
side to the lower side or vice versa, remove ES-101.
Tips
The following describes the procedure to remove ES-101 installed to the upper side of the leading section.
Follow the same procedure when removing ES-101 installed to the lower side of the leading section.
1
Open the top cover of the leading section of the main body of the printer.
4-36
Additional printing on the media with eye mark printed
330 mm/12.99"
4.6
AccurioLabel 230