Change In The Teach-In Mode; Adjust The Sensor Position - Konica Minolta AccurioLabel 230 Quick Manual

4

Change in the teach-in mode

Change the teach-in mode.
1
Long-press the + and - buttons of ES-101 at the same time.
The mode is switched to the teach-in mode.
2
Press the + button twice.
The setting of the teach-in mode can be confirmed.
3
Press the SET button.
The teach-in mode becomes selectable.
4
Press the + or - button to switch the teach-in mode.
LED lights as follows depending on the selected teach-in mode.
% Dynamic teach-in
--........
% Two-point teach-in
........--
5
Press the SET button.
The teach-in mode is set.
6
Long-press the + and - buttons of ES-101 at the same time to return to the normal mode.
4.6.5

Adjust the sensor position

Adjust the longitudinal position and angle of ES-101 to enable detection of the eye mark.
1
Set the media with eye mark.
% For details, refer to page 4-4.
2
Loosen the rotation knob and adjust the longitudinal position and angle of ES-101 so that the red spot
mark projected from ES-101 passes above the eye mark.
4-46
Additional printing on the media with eye mark printed 4.6
AccurioLabel 230