Replacing The Media; Set The Media To The Unwinder Spindle - Konica Minolta AccurioLabel 230 Quick Manual

4.3

Replacing the media

4.3 Replacing the media
This section describes how to replace the media easily by adding the media with using the workbench of
Roll Winder RW-110.
Operate the following procedures to replace the media. Before replacing the media, prepare the following
items.
-
Cutter knife
-
Masking tape (more than 30 mm / 1.18" in width)
-
Ruler
-
Lifter
NOTICE
Before setting or replacing the media, turn on the main power switch and sub power switch of the main
body, and the main power switch and sub power switch of Roll Winder RW-110/Roll Winder RW-210.
Workflow
Set the media to the unwinder spindle: page 4-23
Connect the media using the workbench: page 4-25
Convey the media: page 4-28
4.3.1

Set the media to the unwinder spindle

1
Fix the media with the four included magnets and cut it along the groove for cutter for the workbench
of Roll Winder RW-110.
Be careful not to cut your hand when cutting the media.
AccurioLabel 230
4
4-23