Media Snakes Or Is Mis-Centered - Konica Minolta AccurioLabel 230 Quick Manual

6.5 A media feeding error occurs
6.5.1

Media snakes or is mis-centered

If paper snakes or leans to one side, the edge of the media may be damaged or images may be out of align-
ment.
If a meandering or mis-centering occurs, possible causes are as follows:
-
The media of the rewinder spindle is wound being misaligned.
-
The media is not set in the right position.
-
The conveyor section is dirty with adhesive.
-
The media is not set in the right conveyance position.
Follow the procedures below to solve the problem:
STEP 1: Replace the Media Wound Being Misaligned
 Remove the media wound being misaligned from the rewinder spindle to replace it.
% For details, refer to page 4-29.
STEP 2: Check the Position of the Media
 Check if the media is set in the right position.
% For details, refer to page 5-10.
STEP 3: Clean the Adhesive Sticking on the Parts
 Clean the leading section if it is dirty with adhesive.
% For details, refer to page 5-5.
STEP 4: Adjust the Media Conveyance Position
 Adjust the media conveyance position.
% For details, refer to page 6-20.
STEP 5: Confirm the Air Pressure of the Manometer
 If meandering and mis-centering are not solved even after STEP 4, check the air pressures of the
manometers of the feeding dancer arm, winding dancer arm, and nip.
% For details, contact your service representative.
AccurioLabel 230
6
6-19