High-Speed Logging Mode - Omron SYSMAC FH Series User Manual

OK:Supported processing item, RST: Processing item with restricted support, ---:Unsupported processing item
Processing item
Scan Edge Width
Circular Scan Edge Position
Circular Scan Edge Width
Color Data
Gravity and Area
Labeling
Label Data
Defect
Precise Defect
Fine Matching
Character Inspection
Date Verification
Model Dictionary
2D Codes
Circle Angle
Shape Search III
Intersection
Barcode
*1: The [Subt./Reg.] and [DI Register] measurement modes are not supported.
*2: Re-measured images in Non-Stop Adjustment Mode are logged.
*3: Sensor Controller in Non-Stop Adjustment Mode does not stand by.

High-speed Logging Mode

Normally, the sensor controller executes measurements, image logging, and image display in a designated
order. The FH and FZ5-11
the rest of the cores for measurement processing. This ensures that measurements are always processed at
maximum performance.
Vision System FH/FZ5 Series
User's Manual (Z340)
Support Processing item
OK Precise Calibration
OK User Data
OK Set Unit Data
OK Get Unit Data
OK Set Unit Figure
OK Get Unit Figure
OK Trend Monitor
OK Image Logging
OK Image Conversion Logging
OK Data Logging
OK Elapsed Time
OK Wait
OK Focus
OK Iris
OK Unit Macro
OK Unit Calculation Macro
OK Parallelize
OK Parallelize Task
-series controllers execute those processes with one of the CPU cores, and uses
WWW.NNC.IR
Support Processing item
OK Control Flow Parallel
OK Control Flow Fieldbus
OK Selective Branch
OK Data Output
OK Parallel Data Output
OK Parallel Judgement Output
--- Fieldbus Data Output
OK Result Display
RST(*2) Display Image File
RST(*2) Display Last NG Image
OK OCR
OK OCR User Dictionary
OK
OK
OK
OK
OK
OK
Setting the Operation Mode
RST(*3)
RST(*3)
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
7
281