Precautions For Correct Use - Omron SYSMAC FH Series User Manual

• Do not drop, impose excessive vibration or shock on the product. Doing so may result in malfunction or
burning.
• Since a lithium battery is incorporated, there is a rare case when you are seriously injured due to firing or
blowout.

Precautions for Correct Use

● Installation and Storage Sites
Install and store the product in a location that meets the following conditions:
• Surrounding temperature of 0 to 50°C (−20 to +65°C in storage)
• No rapid changes in temperature (place where dew does not form)
• Relative humidity of between 35 to 85 %
• No presence of corrosive or flammable gases
• Place free of dust, salts and iron particles
• Place free of vibration and shock
• Place out of direct sunlight
• Place where it will not come into contact with water, oils or chemicals
● Orientation of Product
• To keep proper ventilation, install the main unit only the direction as Instruction sheet and manual so that
the ventilation holes are not blocked.
● Ambient Temperature
• To keep proper air flow, keep the top of the Controller 50 mm or more apart from other devices. Install the
controller with a clearance of 30 mm on the right, left side, and 15 mm for rear planes.
• Do not install the product immediately above significant heat sources, such as heaters, transformers, or
large-capacity resistors.
• Do not let the ambient temperature exceed 50°C (122°F).
• Provide a forced-air fan cooling or air conditioning if the ambient temperature is near 50°C (122°F) so that
the ambient temperature never exceeds 50°C (122°F).
● Noise Resistance
• Do not install the product in a cabinet containing high-voltage equipment.
• Do not install the product within 200 mm of power cables.
● Component Installation and Handling
• Touching Signal Lines
To prevent damage from static electricity, use a wrist strap or another device for preventing electrostatic
discharges when touching terminals or signal lines in connectors.
• Handling a USB Memory/SD card (Reference:
Only) (p.256))
To remove a USB memory or SD card, make sure that data is not being read or written to it.
• For USB memory, the LED flashes while data is being read or written, so make sure that it is lit steadily
before removing the memory.
• For SD card, the SD BUSY LED flashes while data is being read or written, so make sure that it is turned
OFF before removing the memory.
• Turning OFF the Power
Do not turn OFF the power while a message is being displayed indicating that processing is being
performed. Data in memory will be corrupted, and the product may not operate correctly the next time it is
started.
18
Using External Memory Devices (FH and FZ5-11
WWW.NNC.IR
Vision System FH/FZ5 Series
User's Manual (Z340)