Xilinx Zynq UltraScale+ ZCU208 User Manual page 50

Table 20: Power and Status LEDs (cont'd)
Schematic Net
Ref. Des.
DS4 PS_RESET_B
DS5 PS_ERR_OUT
DS6 PS_ERR_STATUS
DS7 USB3 MIC2544 U7
FLG
P1-R ENET_LED_0
DS8 ENET_LED_1
P1-L ENET_LED_2
DS9 MSP430_LED0
DS10 MSP430_LED1
DS19 VCC12_SW
DS20 VCCINT_PG
DS21 VCCINT_IO_BRAM_PS_
PG
DS22 VCC1V8_PG
DS23 VCC1V2_PG
DS24 VADJ_FMC_PG
DS25 MGTAVCC_PG
DS26 DAC_AVCC_PG
DS27 MGT1V2_PG
DS29 MGTRAVCC_PG
DS30 MGT1V8_PG
DS31 VCCINT_AMS_PG
DS32 ADC_AVCC_PG
DS34 ADC_AVCCAUX_PG
DS36 DAC_AVTT_PG
DS37 UTIL_1V13_PG
DS38 UTIL_2V5_PG
DS39 UTIL_3V3_PG
DS40 UTIL_5V0_PG
DS41 PS_DDR4_VTERM_0V6
0_PG
DS42 PL_C0_DDR4_VTERM_
0V60_PG
DS43 PL_C1_DDR4_VTERM_
0V60_PG
DS44 DAC_AVCCAUX_ON
DS46 LED_0
UG1410 (v1.0) July 8, 2020
ZCU208 Board User Guide
LED
Name Color
Red POR U5 asserts RESET_B low when any of the monitored voltages (IN_)
falls below its respective threshold, any EN_ goes low, or MR is asserted.
Red PS error out is asserted for accidental loss of power, an error in the
PMU that holds the CSU in reset, or an exception in the PMU.
Red PS error status indicates a secure lockdown state. Alternatively, it can be
used by the PMU firmware to indicate system status.
Green PS USB 3.0 ULPI VBUS power error
Green EPHY U33 link established (all speeds) (RJ45 bezel right)
Green EPHY U33 1000BASE-T link established
Green EPHY U33 link activity (RJ45 bezel left)
Blue MSP430 U38 GPIO LED
Green MSP430 U38 GPIO LED
Green 12VDC power on
Green VCCINT 0.85VDC power On
Green VCCPSINTFP/LP/block RAM/I/O 0.85VDC power on
Green VCC1V8 1.8VDC power on
Green VCC1V2 1.2VDC power on
Green VADJ_FMC 1.8VDC (nom.) power on
Green MGTAVCC 0.9VDC power on
Green ADC_AVCC 0.925V power on
Green MGT1V2 1.2VDC power on
Green MGTRAVCC 0.85VDC power on
Green MGT1V8 1.8VDC power on
Green VCCINT_AMS 0.85VDC power on
Green ADC_AVCC 0.925VDC power on
Green ADC_AVCCAUX 1.8VDC power on
Green DAC_AVTT 2.5VDC power on
Green UTIL_1V13 1.13VDC power on
Green UTIL_2V5 2.5VDC power on
Green UTIL_3V3 3.3VDC power on
Green UTIL_5V0 5VDC power on
Green PS_DDR4_VTERM 0.6VDC power on
Green PL_C0_DDR4_VTERM 0.6VDC power on
Green PL_C1_DDR4_VTERM 0.6VDC power on
Green DAC_AVCCAUX 1.8VDC power on
Green USER GPIO LED_0
Chapter 3: Board Component Descriptions
Description
Send Feedback
www.xilinx.com
50