Christie APS Series Service Manual page 76

Wiring of POWER UNIT CIRCUIT SUB ASSY
Connection of AC cable (CNAC) and wiring of POWER UNIT FAN lead
Connect CNAC to POWER UNIT CIRCUIT. Refer to ① below.
Attach POWER UNIT CIRCUIT FAN to POWER UNIT CIRCUIT HOLDER, and wire FAN lead. Refer to ② below.
Magnified picture
Take the POWER UNIT CIRCUIT FAN lead out of the holder through this slit.
Close the clamp after passing the POWER UNIT CIRCUIT FAN lead
(its length adjusted in advance) through it.
LWU650-APS/LWU530-APS
Service Manual
LWU650-APS / LWU530-APS
POWER UNIT CIRCUIT PCB
Insert the white/black cable
into CN101.
Get the round connector of earth cable
of CNAC touched the detent of fixing
metal of POWER UNIT, and screw it
down to the fixing metal.
POWER UNIT CIRCUIT HOLDER
POWER UNIT CIRCUIT FAN
75
POWER UNIT CIRCUIT assy is
completed by attaching
①POWER UNIT CIRCUIT PCB and
②POWER UNIT CIRCUIT HOLDER
shown above.
At this stage, the only cable to be
attached is CNAC.
020-001522-01 Rev. 1 (11-2018)
LIT MAN SERV APS Series