Christie APS Series Service Manual page 77

Wiring between AC INLET and POWER UNIT CIRCUIT
(1) Attachment of POWER UNIT CIRCUIT ASSY after attaching PANEL DUCT assy
Refer to the following for wiring of CNAC (AC inlet).
Inlet connector
Pass CNAC over the panel duct at the point they crossed.
CNAC
(AC INLET cable)
Slits for the cores
Grooves for the
two cores
Clamp
[Procedure for attaching CNAC]
① Put two cores in the grooves for the cores described above so that they will not be out of the groove.
Put the earth cable first under the white/black cables. Pass three cables in the slit.
② Close the two clamps after passing CNAC through them.
③ Pass CNAC under the cover before crossing the panel duct so that CNAC will not come out.
Pass CNAC over the panel duct at the point they crossed.
④ Attach the inlet connector of CNAC to the bottom case.
⑤ Double-check that the cores are not out of the grooves.
(2) Attachment of AC inlet
Attach AC inlet as shown in the following picture. (Pay attention not to attach it upside down.)
OK
[NOTE]
Attach AC INLET so that its cutouts
will be downwards.
Get the round connector of earth cable
touched the detent of fixing metal of
POWER UNIT, and screw it down.
LWU650-APS/LWU530-APS
Service Manual
LWU650-APS / LWU530-APS
CAUTION
[CNAC cover]
Pass CNAC under here (the cover)
so that it will not come out upwards.
It is OK if one out of three cables is
covered (hooked).
POWER UNIT CIRCUIT ASSY
Bad
Magnified picture of wiring of
POWER UNIT CIRCUIT side.
CNAC
76
Fix CNFL1 and CNFL2 by curling
it once to this clamp without making
excessive length until the engine is installed.
It is for preventing CNFL1 and CNFL2 from
interfering with the engine.
After the engine is installed, remove CNFL1
and CNFL2 from the clamp and stretch them
towards the PANEL FAN lead.
Be sure not to pinch CNFL1 and CNFL2
taken out from the PANEL DUCT in the gap
between the PANEL DUCT and the rib of
BOTTOM CASE indicated by the arrow.
Make sure that it does not cover the boss
for installing the engine by executing fixing
procedure A in order not to make excessive
length of the cables.
020-001522-01 Rev. 1 (11-2018)
LIT MAN SERV APS Series