Christie APS Series Service Manual page 48

Wiring of MAIN PCB - 4
Wiring of MAIN PCB B-side (the side which connector equipped on) (2 of 2)
Wire the cable for each connector according to the picture below.
MAIN PCB B-side
(the side which connector equipped on) (2 of 2)
E800 : Connected to CNMPW
(POWER UNIT CIRCUIT) (equipped on A-side)
LWU650-APS/LWU530-APS
Service Manual
LWU650-APS / LWU530-APS
E801 : Connected to (B PANEL FAN)
E802 : Connected to (G PANEL FAN)
EW31 : Connected to CNFL1
(External air sensor PCB)
E805 : Connected to
(POWER UNIT CIRCUIT FAN)
EW77 : Connected to CNOPR
(Illuminance sensor red)
NOTE
Put R PANEL FAN cable, CNFL1, and
CNFL2 in a red dotted circle under the
MAIN PCB after connecting them.
It prevents the cables from being pinched
by a fastening boss of the upper case
engaged in a part shown by a red circle.
EW32 : Connected to CNFL2
(Internal air sensor PCB)
E807 : Connected to (R PANEL FAN)
Connect R PANEL FAN cable to the connector
of the MAIN PCB after wiring it around CNFL1
and CNFL2 clockwise once.
47
R PANEL FAN cable
020-001522-01 Rev. 1 (11-2018)
LIT MAN SERV APS Series